|
The Internet's Largest and Fastest Growing Engraving Community
Discuss hand engraving using basic to the most advanced methods and equipment
Forum Members: 14,761. Welcome to our newest member, AnicaLin
EngravingForum.com -
Domain since Feb 7, 2003
Graver Video Conferencing is empty Join now!
|
|||||||
| ENGRAVING TOOLS - Paypal accepted | Classes | Glossary | Feedback | Tips | Sharpening | Bulino | Videos | Forum Policies |
 |
|
|
Thread Tools |
|
#1
06-13-2020, 09:22 PM
|
|||
|
|||
Newbie from Calgary Alberta
Hello,
I just picked up the bench graver from steve and its amazing. Looking forward to learning as much as i can on engraving. I will mostly be using it to cut settings for jewellery. I have used a scuba tank to power the system instead of a compressor as it has clean dry air and i have several kicking arround. Also it should run the system for over a month of heavy use. Thanks Luke Last edited by Luke_Weiser; 06-13-2020 at 09:25 PM. Reason: Missed some information 
|
|
#2
06-16-2020, 02:53 AM
|
|||
|
|||
|
Re: Newbie from Calgary Alberta
I’d love to hear what sort of mileage you get out of your tank.. i set up for scuba but haven’t hooked it up except in emergencies..
|
|
#3
06-25-2020, 07:10 PM
|
|||
|
|||
|
Re: Newbie from Calgary Alberta
I have been playing with it for 3 weeks now, but i dont have a pressure gauge on it yet so not sure how much it has dropped. Cant see it being more than 100 psi though. Ill get on it and confirm that for you.
|
|
#4
06-25-2020, 11:12 PM
|
|||
|
|||
|
Re: Newbie from Calgary Alberta
cool.
incidentally i just so happen to be borrowing a piece back from a calgarian for a show.
|
|
| Bookmarks |
|
|
