![]() |
The Internet's Largest and Fastest Growing Engraving Community
Discuss hand engraving using basic to the most advanced methods and equipment
Forum Members: 14,760. Welcome to our newest member, SamWall
EngravingForum.com -
Domain since Feb 7, 2003
Graver Video Conferencing is empty Join now!
|
ENGRAVING TOOLS - Paypal accepted | Classes | Glossary | Feedback | Tips | Sharpening | Bulino | Videos | Forum Policies |
![]() |
|
Thread Tools |
#1
|
|||
|
|||
![]()
Hi,I wanted to ask, how should I face the drawing and later engraving on a cylinder cone 44mm long and cone of 12mm ...and 16mm, thanks
|
#2
|
||||
|
||||
![]()
I would make a paper pattern wrapped around the cone then flatten out the paper and draw my design on the paper...make a transfer from the pattern and place on the cone for engraving. I assume the 12 and 16 mm dimensions are diameters of the ends of the cone.
PS...that would be about the size of a 1 and 3/4 inch section of a rifle barrel near the muzzle. But more taper.
__________________
Sam Welch A.I.E. Guns, guitars and old cars |
#3
|
|||
|
|||
![]()
Yes , thank you very much.
|
![]() |
Bookmarks |
|
|