![]() |
The Internet's Largest and Fastest Growing Engraving Community
Discuss hand engraving using basic to the most advanced methods and equipment
Forum Members: 14,760. Welcome to our newest member, SamWall
EngravingForum.com -
Domain since Feb 7, 2003
Graver Video Conferencing is empty Join now!
|
ENGRAVING TOOLS - Paypal accepted | Classes | Glossary | Feedback | Tips | Sharpening | Bulino | Videos | Forum Policies |
![]() |
|
Thread Tools |
#1
|
|||
|
|||
![]()
I'm sure that this has been asked a 100 times but I can't find anything on this. Well sorry about that folks after looking a little harder I see there are plenty of posts and good info on my question! Found all I was looking for
|
#2
|
|||
|
|||
![]()
Airs fine. Use only an oil free compressor with a water trap.
|
#3
|
||||
|
||||
![]()
Hi Jack, Either Co2 or compressed air works. Here is a thread about cfm usage
http://www.engravingforum.com/showth...5147#post15147 Co2 is great for being portable but If you are working at a permanent location it is hard to beat an air compressor since it does not require refilling.
__________________
__________________________________ Steve Lindsay AirGraver.com EngravingArtist.com |
![]() |
Bookmarks |
|
|