|
The Internet's Largest and Fastest Growing Engraving Community
Discuss hand engraving using basic to the most advanced methods and equipment
Forum Members: 14,761. Welcome to our newest member, AnicaLin
EngravingForum.com -
Domain since Feb 7, 2003
Graver Video Conferencing is empty Join now!
|
|||||||
| ENGRAVING TOOLS - Paypal accepted | Classes | Glossary | Feedback | Tips | Sharpening | Bulino | Videos | Forum Policies |
 |
|
|
Thread Tools |
|
#1
09-05-2017, 12:33 PM
|
|||
|
|||
Quenching gravers
I have searched but could not find out if it is OK to quench M42 gravers. I know not to quench the Carbalt.
__________________
festina lente make haste slowly A. Caesar 
|
|
#2
09-05-2017, 06:36 PM
|
|||
|
|||
|
Re: Quenching gravers
Quote:
How are your gravers heating up? Or perhaps a better question, how come your gravers are heating up? My gravers never get much above room temp... neither during sharpening nor when I use them. Doug
|
|
#3
09-05-2017, 11:14 PM
|
||||
|
||||
|
Re: Quenching gravers
Hi Gail, Wouldn't matter... I generally try not and get them hot. If grinding, I monitor with fingers close to tip and when hot dip in water. M42 can should be able to take quite a bit of heat before it starts to anneal (soften). Here is a an old thread about them.http://www.engravingforum.com/showthread.php?t=11616
__________________
__________________________________ Steve Lindsay AirGraver.com EngravingArtist.com
|
|
| Bookmarks |
|
|
