|
The Internet's Largest and Fastest Growing Engraving Community
Discuss hand engraving using basic to the most advanced methods and equipment
Forum Members: 14,761. Welcome to our newest member, AnicaLin
EngravingForum.com -
Domain since Feb 7, 2003
Graver Video Conferencing is empty Join now!
|
|||||||
| ENGRAVING TOOLS - Paypal accepted | Classes | Glossary | Feedback | Tips | Sharpening | Bulino | Videos | Forum Policies |
 |
|
|
Thread Tools |
|
#1
02-11-2021, 09:59 PM
|
|||
|
|||
Silver set screw?
Found a little silver set screw on the floor this morning. Heard it fall from my shop coat when I put it on. The only thing I used yesterday was my AirGraver. It’s not from the collet. It uses a smaller Hex wrench than the one for the collet. Does it belong on my hand piece somewhere?
Thanks. 
|
|
#2
02-12-2021, 05:24 AM
|
|||
|
|||
|
Re: Silver set screw?
I think the best bet is to compare your handpiece with the manual that was sent with the airgraver. There is a part where every screw is described what it does. If you lost a screw from the airgraver you should finde the missing one like that. But i cant imagine that a screw just fell out of the graver like that.
|
|
#3
02-12-2021, 08:07 AM
|
|||
|
|||
|
Re: Silver set screw?
Just talked to Steve about this. He called to help me identify it. I have a foot control and he says it doesn’t belong to my hand piece. So not sure where it came from. Thanks!
Last edited by Montana Nancy; 02-12-2021 at 10:26 AM. Reason: Talked to Steve—problem taken care of.
|
|
#4
02-17-2021, 05:03 AM
|
|||
|
|||
|
Re: Silver set screw?
Sounds to me like it's a case of just another engraver with a screw loose...
Sorry, sorry, I couldn't help it, it was too easy.
|
|
| Bookmarks |
|
|
