![]() |
The Internet's Largest and Fastest Growing Engraving Community
Discuss hand engraving using basic to the most advanced methods and equipment
Forum Members: 14,761. Welcome to our newest member, Bruno
EngravingForum.com -
Domain since Feb 7, 2003
Graver Video Conferencing is empty Join now!
|
ENGRAVING TOOLS - Paypal accepted | Classes | Glossary | Feedback | Tips | Sharpening | Bulino | Videos | Forum Policies |
![]() |
|
Thread Tools |
#1
|
|||
|
|||
![]()
can I use the air regulator I have for my Lindsay Air Graver to also run a rotary tool, NSK?
|
#2
|
|||
|
|||
![]()
You should be able to. I have the foot control classic and run steve lindsays bench jewel rotary tool off the auxiliary port. The nsk presto is set up in the same way as steves tool off the regulator. I have the nsk and the bench jewel and both use seemingly the exact same pedal. The only issue i can see would be that the presto says specifically to use 35 psi. Whereas when i asked steve about what psi to run the bench jewel he said he uses it at whatever the classic is set to. So the psi can be varied. Because of this i run the presto off its own regulator and keep it at 35 psi as recommended by the manufacturer.
|
#3
|
|||
|
|||
![]()
Yes.
|
![]() |
Bookmarks |
|
|