![]() |
The Internet's Largest and Fastest Growing Engraving Community
Discuss hand engraving using basic to the most advanced methods and equipment
Forum Members: 14,760. Welcome to our newest member, SamWall
EngravingForum.com -
Domain since Feb 7, 2003
Graver Video Conferencing is empty Join now!
|
ENGRAVING TOOLS - Paypal accepted | Classes | Glossary | Feedback | Tips | Sharpening | Bulino | Videos | Forum Policies |
![]() |
|
Thread Tools |
#1
|
|||
|
|||
![]()
Hey, my name is Josh and I do hammer and chisel engraving mostly on aluminum motorcycle parts. I have probably got 40 or 50 hours into this craft and I have taken a liking to carving old tattoo flash.
My handles are steel turned on a lathe that I keep oiled with some good ol' 5W-30, my chisel points are sharpened by hand without fixtures (please don't crucify me). Only using a flat tip graver and square tip graver right now (but they are genuine Lindsay HSS blanks, I didn't skimp there!). My background stippling is done with a wood nail that I reshape on the bench grinder from time to time. Here is the most recent thing I "finished." It is done on an old sportster primary cover that I am using for practice. EDIT: got the pics to work ![]() ![]() Last edited by VDSlugg; 07-18-2019 at 02:43 PM. Reason: Pictures |
#2
|
|||
|
|||
![]()
Where are you located in NC? Looked at your profile and no location listed.
|
#3
|
|||
|
|||
![]()
Raleigh
|
#4
|
|||
|
|||
![]()
Not too far from here. There are quite a few noted engravers within your reach if you need any advice or help.
|
#5
|
||||
|
||||
![]()
you have a good start but as you know hammer and chisel are very slow, getting some sharpening templates will help
|
![]() |
Bookmarks |
|
|