My first cut with a Palmcontrol. - Engraving Forum.com - The Internet's Largest and Fastest Growing Engraving Community

rbaptiste · #1 11-17-2007, 06:48 AM

I receive yersterday my Palmcontrol from Steve.
After a few hours I doing my exercise plate.
Really good cut and easy to work with it.
Iworked with the GRS tools and I wanted to wait a few months before you sell my tools GRS but after a few hours with the Palm, I think I can sell it tomorrow.

jack · #2 11-17-2007, 07:57 AM

Great, another member to the group, Ha. Jack

rbaptiste · #3 11-20-2007, 09:49 AM

I have but one regret, not having had earlier!
Thank you for your comments

Rich Hambrook · #4 11-25-2007, 10:06 AM

You do amazing work!:whoo: I am a engraver for Browning at the St. Louis plant and I see that you do a lot of work on Browning Superposed. Fabulous work. I enjoyed watching your video but I wish I spoke your language. Please keep the photo's coming. One question, I have been trying to find more vices like the one you use for the H&C. I have the same one but I would like to find a couple more for some students. Any idea's?
Rich Hambrook

rbaptiste · #5 11-25-2007, 10:42 AM

Thanks.
In Belgium there is a lot B25 to customized.
My father was an engraver to Browning too and my vise come from FNHerstal.
Now it's very difficult to find it.
It's the better for engraving with the hammer.
With my airgraver it's more easy with a ball vise.