Looking to start engraving

[MKETOOL]

I am currently looking to get into engraving guns, but I don't really want to spend the money on a new engraver if it turns out I am not good at it. I am pretty artistic and good with my hands, so I think I can learn. My question is, does anyone have a used airgraver they may want to sell. You can email me at timg1@att.net Thank you, Tim

[K Frei]

hello. i would have to say to you that on this webe site if you go down to the bottom of the page and on the right side there is a forum jump. of you then scroll to engraving forum there is a note there on an inexpencive way to give it a try.

[IUinvictus]

you can make this for 6$ and it works pretty well to see if your any good. I just screwed a piece of steel to a work bench and used an old tac hammer. its a lot of fun.